BEEPER SR2-N Anti-skid tyre straps

BEEPER Snowrings SR2-N is a reusable emergency traction aid designed for all motorists. This innovative product allows drivers to easily and quickly get out of their vehicle from critical situations of poor traction: ice, mud, snow, etc.

Easy to install, BEEPER Snowrings SR2-N is suitable for most passenger car tires and can be installed in a few minutes on alloy and aluminum rims, it is not suitable for sheet metal and steel rims (with protruding edges).

BEEPER Snowrings SR2-N is an ideal solution for emergency traction assistance:

- Very economical and easy to use.
- Very easy installation in a few minutes without any knowledge.
- Rubber grip + metal hook for extra grip on snow, ice and mud.
- Easy storage in the trunk or on the back seat.
- Easy to carry with its bag!

- Ideal for snow, ice, mud
- Emergency traction solution in case of blocking, getting stuck, skidding
- Quick and easy installation in less than 2 minutes per wheel
- Fits most vehicle wheels (sedan, 4x4, camper, van)
- Reusable zip tie

Kit content
- 10 anti-slip collars (5 per wheel)
- 1 pair of protective gloves
- 1 installation manual
- 1 carrying bag

100% quick & easy installation
Want to make your life easier? With the BEEPER Snowrings SR2-N, clearing your vehicle becomes child's play!

/! Before installation, determine the direction of rotation of the wheel in order to free yourself (forward or reverse). Place the clamp on the rim post according to the direction of rotation as shown in the diagram below.

1. Be sure to tighten the clamp as close to the tire as possible, to prevent movement of the clamp and ensure maximum efficiency.
2. Place the clamp around the wheel of the tire, tightening it as much as possible against the tire and rim, then pass the rod through hole #1 and the bottom outlet, and tighten firmly.
3. Place the clamp through hole #2, the clasp and the middle exit, and tighten firmly.
4. Finally, pass the rest of the collar through hole #3 and the top exit, tightening firmly.
5. Get out of there and roll! Depending on your level of locking, you can use 3 to 5 clamps per wheel and on one or both drive wheels at the same time. The use of the clamps is temporary until you are clear of the jammed area. The clamps are reusable, just remove them and store them in their bag.

/! Be careful not to install the clamp closure system near the tire valve.

It is not recommended to drive more than 20 km/h in order not to destroy the clamps.

Dimensions

Each collar is 985 mm long and 55 mm wide. The thickness is 2,5 mm on the length and 30 mm for the part with the clasp.

Suitable for wheels with a maximum circumference of 740 mm. For example, a large tire size 255 (width) / 70 (height) / R18 (? of the rim) is compatible. To check the compatibility of your tire, calculate the perimeter : (width x 2 + height x 2) + 10%, this total must be less than 740 mm.

Precautions for installation and use

Product designed for alloy wheels (or aluminum rims), do not install on sheet metal rims.

This product cannot be considered as a special equipment according to the decree of July 18, 1985 relating to the anti-skid devices equipping the tires, it is defined as a removable winter equipment and is considered only as a starting device with very exceptional use.